Correcting The Misalignment Of The Printing And Cutting Positions During Cutting - Roland TrueVIS VG2-640 User Manual

Accurately Adjusting the Settings for Printing and Cutting

Correcting the Misalignment of the Printing and Cutting Positions during Cutting

This method pauses a cutting operation to correct the misalignment of the printing and cutting positions. The
correction values set here are applied as the default values of the printing and cutting positions.
If the printing and cutting positions are misaligned, you normally adjust the positions while checking a test pat-
tern.
P. 169「Correcting the Misalignment of Printing and Cutting」
Procedure
1.
During cutting, press [PAUSE] to display the screen shown below.
TO CANCEL
DOWN PAUSE KEY
The cutting operation is paused.
2.
Press [FUNCTION].
3.
Press [▼] several times to display the screen shown below.
FUNCTION
CUT CONFIG
4.
Press [▶] once, and then press [▼] several times to display the screen shown below.
CUT CONFIG
PRINT-CUT ADJ.
5.
Press [▶].
6.
Determine the correction values.
MEMO
Determine the values so as to correct the misalignment of the cutting position (
the case of the following figure, feed direction "F" is misaligned in a negative direction and scan direction "S" in a positive
direction. Therefore, set the correction values for the feed direction "F" to positive values and the scan direction "S" to negative
values. Measure the actual misalignment amount when determining the value.
7.
Set the correction values for the feed direction "F" and the scan direction "S."
(1)
Press [▲] or [▼] to set the correction value for the feed direction (F).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(2)
Press [◀] or [▶] to set the correction value for the scan direction (S).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(3)
When you have finished setting the correction values, press [ENTER].
8.
Press [PAUSE] to display the screen shown below.
172
1. Optimizing the Output Quality
HOLD
) in relation to the printing position (
[F]
[S]
). In