Setting The Dryer Temperature - Roland TrueVIS VG2-640 User Manual

Adjusting the Ink-drying Method

Setting the Dryer Temperature

Setting the temperature of the dryer appropriately makes the ink dry fast.
• With the default settings, simply switching on the power does not make the dryer warm up to the set temper-
ature. The temperature rises to the set temperature when the media is loaded correctly and [SETUP] lights.
• Depending on the usage environment, the temperature of the print heater may become higher than the set
temperature, but this does not represent a problem.
• Temperature settings are not possible when heater settings "POWER" is "OFF".
Procedure
1.
Press [FUNCTION].
2.
Press [▼] several times to display the screen shown below.
FUNCTION
HEATER CONFIG
3.
Press [▶] once, and then press [▼] twice to display the screen shown below.
HEATER CONFIG
DRYER
4.
Press [▶] to display the screen shown below.
DRYER
50゜C
5.
Press [▲] or [▼] to select the temperature.
When ink drying is poor, raise the temperature. Note, however, that a temperature that is too high may de-
grade the media or cause it to wrinkle.
You can also set the temperature to "OFF". When set to "OFF", the dryer does not operate at all.
6.
Press [ENTER] to confirm your entry.
7.
Press [FUNCTION] to go back to the original screen.
MEMO
• Default setting: 45°C (113°F)
• You can also make this setting in the software RIP. When you have made the setting in the software RIP, the software RIP's
setting is used.
154
1. Optimizing the Output Quality
40゜C
50゜C