Procedure
1.
Press [◀] to select "SET".
CUT CONFIG
[SET] NEXT
2.
Press [ENTER] to confirm your entry.
3.
Press [◀] to select "SET".
CUT FORCE
[SET] NEXT
4.
Press [ENTER] to confirm your entry.
The test pattern is cut.
You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.
5.
Peel off the two cut shapes (a circle and a square).
6.
Check how the two shapes peel off.
• Two shapes are peeled off together/backing paper is also cut
Press [◀] to select "YES".
CONTINUE ADJ.?
[YES] DONE
• Two shapes are peeled off separately
Press [▶] to select "DONE".
CONTINUE ADJ.?
YES [DONE]
7.
Press [ENTER] to confirm your entry.
• If you select "YES", proceed to the next procedure.
• If you select "DONE", proceed to step
.
marks.(P. 125)
8.
Press [▲] or [▼] to adjust the blade force.
• If the two shapes are peeled off together → increase the blade force.
• If the backing paper is also cut → reduce the blade force.
CUT FORCE
50gf
9.
Press [ENTER] to confirm your entry.
The test pattern is cut again. Check the result.
10.
Check how the two shapes peel off.
• Two shapes are peeled off together/backing paper is also cut
Press [◀] to select "YES".
7.Correct the misalignment of the printing and cutting positions when using crop
60gf
Cutting with Crop Marks
4. How to Cut with Crop Marks
123