Preventing Misaligned Media; Use Middle Pinch Rollers When Pulling Back Or Feeding Media - Roland TrueVIS VG2-640 User Manual

Preventing Misaligned Media

Use Middle Pinch Rollers When Pulling Back or Feeding Media

Set the setting that causes the middle pinch rollers to go up automatically during pullback printing or printing and
cutting to "DISABLE." Holding down media that is not straight or comes loose is effective in preventing misalign-
ment during printing and cutting.
"AUTO MIDDLE PINCH" is a function that causes the middle pinch rollers to automatically rise when media is
pulled back, performs overprinting and cutting while they are raised. However, if you are performing lengthy print-
ing or using non-resilient media, the media will be skewed or will come loose, which may have an effect on the
output quality.
If you set "AUTO MIDDLE PINCH" to "DISABLE", the middle pinch rollers will press down on the media while mov-
ing, thus preventing skewing or coming loose. However, because the middle pinch rollers are pressed against the
printed surface, it is easier for the rollers to leave a trace on the printed surface. Before pulling back the media,
make sure to dry it thoroughly.
P. 152「Adjusting the Ink-drying Method」
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
SUB MENU
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
SUB MENU
AUTO M.PINCH
4.
Press [▶].
5.
Press [▲] or [▼] to select "DISABLE".
AUTO M.PINCH
ENABLE DISABLE
6.
Press [ENTER] to confirm your entry.
7.
Press [MENU] to go back to the original screen.
MEMO
• Default setting: "ENABLE"
1. Optimizing the Output Quality
151