Roland TrueVIS VG2-640 User Manual page 102

6.
Set the blade force.
For high-quality cutting, perform a cutting test to check the cutting quality for the media and adjust the blade
force.
Procedure
1.
Press [◀] to select "SET".
CUT CONFIG
[SET] NEXT
2.
Press [ENTER] to confirm your entry.
3.
Press [◀] to select "SET".
CUT FORCE
[SET] NEXT
4.
Press [ENTER] to confirm your entry.
The test pattern is cut.
You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.
5.
Peel off the two cut shapes (a circle and a square).
6.
Check how the two shapes peel off.
• Two shapes are peeled off together/backing paper is also cut
Press [◀] to select "YES".
CONTINUE ADJ.?
[YES] DONE
• Two shapes are peeled off separately
Press [▶] to select "DONE".
CONTINUE ADJ.?
YES [DONE]
7.
Press [ENTER] to confirm your entry.
• If you select "YES", proceed to the next procedure.
• If you select "DONE", proceed to step
8.
Press [▲] or [▼] to adjust the blade force.
• If the two shapes are peeled off together → increase the blade force.
• If the backing paper is also cut → reduce the blade force.
CUT FORCE
50gf
9.
Press [ENTER] to confirm your entry.
The test pattern is cut again. Check the result.
7.Correct the misalignment of the printing and cutting positions.(P. 103)
60gf
Printing and Cutting Output
3. Printing and Cutting Method
.
101