Roland TrueVIS VG2-640 User Manual page 128

8.
Set the drying method and time after printing.
Procedure
1.
Press [▲] or [▼] to select "ENABLE" or "DISABLE".
Set whether the media should be fed until the trailing edge of the printed area is put on the dryer after the
1st page is printed. To make sure to dry the entire printed area, select "ENABLE". If "DISABLE" is selected,
the trailing edge of the printing area is not fed to the dryer unless you continue with a subsequent printing
operation.
FEED FOR DRY
DISABLE ENABLE
2.
Press [ENTER] to confirm your entry.
3.
Press [▲] or [▼] to set the drying time.
Set the drying time after the 1st page is printed. The next operation is not started until the set time passes.
DRYING TIME
10min 10min
MEMO
This setting is enabled for output data designed only for printing.
This setting is ignored for output data designed for printing and cutting. When the drying time has been set in the software RIP,
priority is given to the software RIP's setting.
Example of setting time (general guide)
The setting time varies according to the settings such as the type of media and the printing quality.
• Condition Non-coated vinyl chloride media
• Setting time: About three minutes
4.
Press [ENTER] to confirm your entry.
5.
Press [▲] or [▼] to set the drying time.
DRY TIME P&C
10min 10min
MEMO
This setting is enabled for output data designed for printing and cutting.
This setting is ignored for output data designed only for printing. This setting is also applied during printing and cutting with
crop marks. Even if the drying time has been set in the included software RIP, priority is given to the setting on this machine.
6.
Press [ENTER] to confirm your entry.
Cutting with Crop Marks
4. How to Cut with Crop Marks
127