Setting The Drying Time After Printing (When Printing And Cutting) - Roland TrueVIS VG2-640 User Manual

Setting the Drying Time after Printing (When Printing and Cutting)

To dry the ink thoroughly, set the drying time after the 1st page is printed. This setting applies to output data de-
signed for printing and cutting.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
HEATER MENU
3.
Press [▶] once, and then press [▼] several times to display the screen shown below.
HEATER MENU
DRYING TIME
4.
Press [▶], then [▼] to display the screen shown below.
DRYING TIME
P&C
5.
Press [▶] to display the screen shown below.
P&C
0min
6.
Press [▲] or [▼] to select the drying time.
7.
Press [ENTER] to confirm your entry.
8.
Press [MENU] to go back to the original screen.
MEMO
• Default setting: 0 min
• The next operation is not started until the set time elapses.
• During drying, [PAUSE] is lit. Press [PAUSE] while [PAUSE] is lit to finish the drying time and start the next operation.
• Hold down [PAUSE] while [PAUSE] is lit to cancel the output.
• When you have configured this setting, we recommend setting the [FEED FOR DRY] menu to "ENABLE" or "P&C". ()
• This setting is also applied during printing and cutting with crop marks.
• Even if the drying time has been set in the included software RIP, priority is given to the setting on this machine.
• This setting is ignored for output data designed only for printing. To set the drying time after printing when only printing, see
the following section.
RELATED LINKS
・ P. 158 "Setting the Drying Time after Printing (When Only Printing)"
0min
Adjusting the Ink-drying Method
1. Optimizing the Output Quality
159