Messages; Close Cover (Front Cover/Cover L/Cover R); Sheet Not Loaded Press Setup Key; Close Slot Cover - Roland TrueVIS VG2-640 User Manual

Messages

These are the main messages that appear on the machine's display to prompt correct operation. They do not indi-
cate any error. Follow the prompts and take action accordingly.
1 ■ 2 ■ 3 ■ 4 ■ 5■ 6 ■ 7 ■ 8 ■
Only a small amount of ink remains.
Replace the ink pouch indicated by the flashing number with a new pouch.

CLOSE COVER (FRONT COVER/COVER L/COVER R)

The front, left, or right cover is open. For safety, some carriage operations are limited while a cover is open.
Close the front, left, or right cover.

SHEET NOT LOADED PRESS SETUP KEY

This message appears when an attempt to perform a printing test was made while no media was loaded.
Load media.

CLOSE SLOT COVER

This message appears if the ink slot cover is open when output starts.
Close the ink slot cover.

END OF THE SHEET

The trailing edge of the media was detected during operation.
Press any key on the operation panel to clear the message. Load new media.

EMPTY DRAIN BOTTLE

This message appears when a certain amount of discharged fluid collects in the drain bottle.
Discard the discharged fluid in the bottle.
RELATED LINKS
・ P. 226 "If the Discharged Fluid Disposal Message Appears"

INSTALL DRAIN BOTTLE

Check whether the drain bottle is installed correctly.
Install the drain bottle, and then press [ENTER].
RELATED LINKS
・ P. 225 "Disposing of Discharged Fluid"
NOW HEATING... NOW PROCESSING..
The media heating system did not reach the set temperature.
Wait until the set temperature is reached. Printing starts when [HEATER] lights. You can stop output by holding
down [PAUSE] for one second or longer while this is displayed. Pressing [PAUSE] makes printing start immediately
without waiting to reach the preset temperature.

TIME FOR MAINTENANCE

It is time to perform manual cleaning.
298
5. Messages on the Operation Panel