Roland TrueVIS VG2-640 User Manual page 192

Menu item
[DRYING TIME]
[DRY TIME P&C]
[MEDIA GAP ADJ. SIMPLE SETTING]
[MEDIA GAP ADJ. DETAIL SETTING]
[CALIBRATION]
[EDGE DETECTION]
[SCAN INTERVAL]
[VACUUM POWER]
[FULL WIDTH S]
[MEDIA RELEASE]
[FORCE], [SPEED], [OFFSET], [UP-SPEED]
[CALIBRATION] (in the [CUTTING MENU])
[PRINT-CUT ADJ.]
[CROP-CUT ADJ.]
[CROP SENSOR ADJ.]
Reference page
P. 158「Setting the Drying Time after Printing (When On-
ly Printing)」
P. 159「Setting the Drying Time after Printing (When
Printing and Cutting)」
P. 139「Adjust the misalignment of the ink landing posi-
tion.」
P. 140「Accurately Adjusting the Misalignment of the Ink
Landing Position」
P. 142「Reducing Horizontal Bands (Feed Correction
Function)」
P. 146「Using Transparent Media」
P. 147「Using Hard-to-Dry Media」
P. 148「Using Media That Wrinkles Easily/Does Not
Move Smoothly」
P. 195「Speeding Up Output for Narrow Media」
P. 149「Using Sticky Media」
P. 163「Fine-tuning the Cutting Conditions」
P. 166「Performing Distance Correction during Cutting」
P. 169「Correcting the Misalignment of Printing and Cut-
ting」
P. 176「Correcting the Misalignment of Printing and Cut-
ting with Crop Marks (Concurrent Test for Printing and Cut-
ting with Crop Marks)」
P. 179「Correcting the Misalignment of Printing and Cut-
ting with Crop Marks (Separate Test for Printing/Cutting with
Crop Marks)」
P. 187「Adjusting the Level of the Sensor for Reading
Crop Marks According to the Media」
2. Optimizing Work Efficiency
Using Presets
191