Separating the Media
Procedure
1.
Close the front cover.
2.
Check that [SETUP] is lit.
3.
Press [FUNCTION].
4.
Press [▼] several times to display the screen shown below.
FUNCTION
SHEET CUT
5.
Press [ENTER].
From its position on the blade protection line prior to [ENTER] being pressed (
position on the separating line (
MEMO
You can configure settings in the software RIP for automatic media separation after output has finished. For information on
how to configure the settings, refer to the documentation for the software RIP you are using.
IMPORTANT
Separation Operations
• When performing separation, do not use [▲] to pull the media back. If the distance from the end of the media to the
separation location is short, separation may not be performed smoothly.
Give Attention to the Media Composition
• For some types of media, separation is not possible.
• Some types of media may remain on the platen after separation. If the media remains on the platen, remove it by hand.
) and is separated.
Setup of Media
), the media moves to a
2. Basic Operations
47