Roland TrueVIS VG2-640 User Manual page 187

Accurately Adjusting the Settings for Cutting with Crop Marks
2.
Check whether crop marks can be read.
Procedure
1.
Press [▲] to display the screen shown below.
CROPSENS CALIB
SENS CHECK
2.
Press [ENTER] to display the screen shown below.
MOVE CUT TOOL
TO MARK CENTER
3.
Press [◀], [▶], [▲] or [▼] to move the center of the blade over the crop marks.
The center of the blade should only be over the crop marks, and does not need to be aligned with the cen-
ter of the crop marks.
4.
Press [ENTER].
Check whether crop marks can be read.
If reading succeeds, the following message appears. Proceed to the next step.
CHECK SUCCESS
MARK FOUND
If reading fails, the following message appears.
CHECK FAILED
MARK NOT FOUND
It is possible that crop marks cannot be detected because they are not the crop marks output from the
software RIP that is compatible with this machine. Crop marks drawn using drawing software also cannot be
detected.
Use the software RIP that is compatible with this machine to output the crop marks and redo the correction
from the start.
If detection failed even with crop marks output by the compatible software RIP, redo the correction from the
sensor correction stage.
5.
Press any one of the keys on the operation panel to display the screen shown below.
CROPSENS CALIB
SENS CHECK
6.
Press [MENU] to go back to the original screen.
186
1. Optimizing the Output Quality