Wrong Cartridge; Canceled For Pump Protection; Avoiding Dry-Up Turn Power Off; Set Head Height To - Roland TrueVIS VG2-640 User Manual

Error Messages
Raise the loading lever and move the pinch roller to the correct location.
RELATED LINKS
・ P. 30 "Setup of Roll Media"
・ P. 40 "Setup of Sheet Media"

WRONG CARTRIDGE

Has an ink pouch that cannot be used been installed?
Remove the pouch tray to clear the error. Use an ink pouch of the specified type.

CANCELED FOR PUMP PROTECTION

The printer made an emergency stop because a state in which ink was not present continued for 10 minutes or
longer while cleaning (normal, medium, powerful, damper, super, or automatic cleaning while sub power was
switched off) was in progress or during the first ink filling procedure for the machine.
Operation cannot be continued. Turn off the sub power. After turning the power off, contact the your authorized
Roland DG Corporation dealer.

AVOIDING DRY-UP TURN POWER OFF

The print heads were forced to the home position to prevent them from drying out.
Operation cannot be continued. Switch the sub power off, and then back on.

SET HEAD HEIGHT TO ****

Is the height of the print heads lower than the height specified in the software RIP?
This warning indicates that the height of the print heads is too low for the media thickness specified in the soft-
ware RIP. The print heads move to a location where you can operate the height-adjustment lever. Adjust to the
displayed height, and then press [ENTER].
RELATED LINKS
・ P. 144 "Adjusting Print Head Height to Match Media Thickness"

MOTOR ERROR: TURN POWER OFF

1. A motor error occurred.
2. The media has jammed.
3. Has the media been pulled with excessive force?
1. Operation cannot be continued. Turn off the sub power. Next, eliminate the cause of the error, then immedi-
ately switch on the sub power. If the machine is allowed to stand with the error uncorrected, the print heads
may dry out and become damaged. This error may be caused by such factors as a mistake in loading the me-
dia, a media jam, or an operation that pulls the media with excessive force.
2. Carefully remove the jammed media. The print heads may also be damaged. Perform head cleaning, and then
perform a printing test and check the results.
3. Excessive tension was applied to the media, and additional action is necessary to recover from this state. First,
raise the loading lever and adjust the media to create a small amount of slack, and then switch on the sub
power.

SERVICE CALL ****

An unrecoverable error occurred or part replacement that must be performed by a service technician is re-
quired.
302
5. Messages on the Operation Panel