Roland TrueVIS VG2-640 User Manual page 85

Cutting Output
CONTINUE ADJ.?
YES [DONE]
13.
Press [ENTER] to confirm your entry.
• If you select "YES", proceed to the next procedure.
• If you select "DONE", proceed to step
14.
Press [▲] or [▼] to adjust the blade force.
• If the two shapes are peeled off together → increase the blade force.
• If the backing paper is also cut → reduce the blade force.
CUT FORCE
50gf
15.
Press [ENTER] to confirm your entry.
The test pattern is cut again. Check the result.
16.
Check how the two shapes peel off.
• Two shapes are peeled off together/backing paper is also cut
Press [◀] to select "YES".
CONTINUE ADJ.?
[YES] DONE
• Two shapes are peeled off separately
Press [▶] to select "DONE".
CONTINUE ADJ.?
YES [DONE]
17.
Press [ENTER] to confirm your entry.
• If you select "YES", the test pattern is cut again. Go back to step 12 and perform the setting again.
• If you select "DONE", proceed to step
84
2. Cutting Method
4.Save the settings as a preset.(P. 85)
60gf
4.Save the settings as a preset.(P. 85)
.
.