Cutting with Crop Marks
8.
Press [ENTER].
INPUT
ADJ. VALUES
9.
Check the correction values from the test pattern (C&C2) condition.
The point where the cutting line (
following figure, the correction value is "−0.3."
Check the media feed direction (the feed direction) and the direction of print head movement (the scan
direction).
10.
Set the correction values for the feed direction "F" and the scan direction "S."
(1)
Press [▲] or [▼] to set the correction value for the feed direction (F).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(2)
Press [◀] or [▶] to set the correction value for the scan direction (S).
F:+0.30 +0.35mm
S:-0.40 -0.45mm
(3)
When you have finished setting the correction values, press [ENTER].
The test pattern (C&C1) is printed and cut again. Check the condition of the test pattern to check
whether the printing position and the cutting position are aligned.
11.
Determine whether to correct the misalignment.
• Cutting position and printing position are not aligned
Press [◀] to select "YES".
CONTINUE ADJ.?
[YES] DONE
• Cutting position and printing position are aligned
Press [▶] to select "DONE".
CONTINUE ADJ.?
YES [DONE]
12.
Press [ENTER] to confirm your entry.
• If you select "SET", the test pattern (C&C1) is printed and cut again. Go back to step 10 and perform the
setting again.
If you select "DONE", proceed to the next procedure.
126
4. How to Cut with Crop Marks
) intersects the correction-value scale (
) is the correction value. In the