Roland TrueVIS VG2-640 User Manual page 264

9.
Replace the blade.
(1)
Press the pin (A) to push out the old blade (B).
(2) Insert a new blade (C).
Orient the tip of the blade (D) correctly.
B
10.
Install the cutting tool in the cutting carriage.
11.
Tighten the screw.
Tug the blade holder upward to make sure it does not come loose.
12.
Close the front cover.
13.
Press [ENTER].
When the following screen is displayed again, the blade replacement is finished.
A
Replacing the Blade/Separating Knife
C
OK Not OK
4. Replacing Consumable Parts
D
263