Roland TrueVIS VG2-640 User Manual page 165

Accurately Adjusting the Cutting Settings
Display screen (cutting conditions)
CUT CONFIG
FORCE
CUT CONFIG
SPEED
CUT CONFIG
OFFSET
CUT CONFIG
UP-SPEED
10.
Press [▶] to display the screen shown below.
FORCE
50gf
SPEED
30 cm/s 30 cm/s
OFFSET
0.250mm 0.250mm
UP-SPEED
20 cm/s 20 cm/s
11.
Press [▲] or [▼] to select a value.
12.
Press [ENTER] to confirm your entry.
13.
Press [◀] to go back to step 9.
Repeat steps 9 and 10 to adjust the cutting conditions.
14.
Press [FUNCTION] to go back to the original screen.
164
1. Optimizing the Output Quality
Set the force (pressure) of the blade.
Set the speed of cutting.
Set the blade offset. Enter the listed offset value for the blade.
The offset value for the included blade is 0.250 mm (9.8 mil).
Set the blade's up speed during cutting (the speed at which the blade
travels when it moves to the next cutting line after cutting one cutting
line). If the media comes loose during no-load feed and the blade
damages the surface of the media, reduce the speed.
50gf
Setting details
Default set-
tings
50 gf
30 cm/s
0.250mm
30 cm/s