Roland TrueVIS VG2-640 User Manual page 104

7.
Correct the misalignment of the printing and cutting positions.
Subtle misalignment between the printing and cutting positions may occur due to the thickness of the media or
the head height. We recommend that you make corrections to match the media you are using.
Procedure
1.
Press [◀] to select "SET".
2.
Press [ENTER] to confirm your entry.
The test pattern (P&C1) is printed and cut. The test pattern is printed at each edge of the media.
You can select "NEXT" and press [ENTER] to skip the current menu and proceed to the next menu.
MEMO
If the media is tilted, the positions at the edges will be misaligned. You can also adjust for misalignments due to the media
being tilted by printing the test pattern at each edge.
3.
Check the test pattern (P&C1).
Check whether the printing position (shaded part) and the cutting position (outer frame) are aligned. An
example of the printing position and the cutting position being misaligned is shown in the following figure.
"F" indicates the feed direction of the media (the feed direction) and "S" indicates the direction of print
head movement (the scan direction).
4.
Determine whether to correct the misalignment.
• Cutting position and printing position are not aligned
Press [◀] to select "YES".
CONTINUE ADJ.?
[YES] DONE
• Cutting position and printing position are aligned
Press [▶] to select "DONE".
CONTINUE ADJ.?
YES [DONE]
5.
Press [ENTER] to confirm your entry.
• If you select "YES", the test pattern (P&C2) for setting the correction values is printed and cut. Proceed
to the next step.
• If you select "DONE",
6.
Press [ENTER].
INPUT
ADJ. VALUES
7.
Check the correction values from the test pattern (P&C2) condition.
The point where the cutting line (
following figure, the correction value is "−0.3."
8.Set the drying method and time after printing.(P. 105)
) intersects the correction-value scale (
Printing and Cutting Output
proceed to step 8.
) is the correction value. In the
3. Printing and Cutting Method
103