Correcting The Misalignment Of Printing And Cutting With Crop Marks (Separate Test For Printing/Cutting With Crop Marks); Correcting The Misalignment Of Printing And Cutting With Crop Marks; Ing/Cutting With Crop Marks) - Roland TrueVIS VG2-640 User Manual

Correcting the Misalignment of Printing and Cutting with Crop Marks (Separate Test for
Printing/Cutting with Crop Marks)
Due to changes in the thickness of media caused by laminating and misalignment of the loading position of the
media before and after cutting, the positioning of printing and cutting may be misaligned even when you are using
crop marks. Make corrections for misaligned printing and cutting for the media you are using and its condition.
In this test, so as to create the same conditions as the actual operation, print only the crop marks, remove the
media, load the media again, and then cut the media.
1.
Adjust the misalignment of the ink landing position.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
MEDIA GAP ADJ.
3.
Press [▲] or [▶] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
4.
Press [ENTER].
Printing of the test pattern starts.
5.
When printing is finished, press [▼], then [▶] to display the screen shown below.
6.
View the printed test pattern, and then determine the correction value.
Select the value that gives the least misalignment between the two lines. In the case of the following figure,
select "-3." When you cannot choose between two sequential numbers, select a value that is between them
(you can set correction values in units of "0.5").
7.
Press [▲] or [▼] to select the correction value.
8.
Press [ENTER] to confirm your entry.
9.
Press [◀] or [▲] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
10.
Press [ENTER].
Printing of the test pattern starts.
11.
Check the test pattern to see whether the correction was successful.
Check that the misalignment is minimized for the two vertical lines indicated by "
correction value). If the misalignment is smaller for another set of vertical lines, set the correction value
again.
12.
When you have successfully performed the correction, press [MENU] to go back to the original screen.
Accurately Adjusting the Settings for Cutting with Crop Marks
" (that is, the current
1. Optimizing the Output Quality
179