Is The Lan Routing Appropriate; Are The Lan Settings Correct; Did The Software Rip End Abnormally; Has The Ink Run Out - Roland TrueVIS VG2-640 User Manual

The Printer Unit Does Not Run

Is the LAN routing appropriate?

Check whether or not the network routing is appropriate. Try connecting the computer and the machine to the
same hub or connecting them directly using a cable. If this makes it possible to perform output, it means the prob-
lem may be in the network itself.

Are the LAN settings correct?

If the cable connections are secure and no problem is found in the network itself, make sure that the IP address
and other such settings are appropriate. The settings on both the machine and the computer must be appropriate.
Redo the settings, checking to ensure that the IP address does not conflict with the IP address for another device
on the network, that the port setting for the software RIP specifies the IP address set on the machine, that the
settings have no typing errors, and for other such problems.
RELATED LINKS
・ P. 214 "Viewing System Information"

Did the software RIP end abnormally?

Make sure the software RIP is running correctly, and then switch the sub power switch off and back on.

Has the ink run out?

1 2 3 4
5 6 7 8
When the screen shown in the figure is displayed, output data cannot be accepted. The error can be resolved by
replacing the ink pouch with a new one. If there is data that has not yet been output remaining in the machine,
output resumes. If there is unsent data in the computer, output resumes when the data is resent.
RELATED LINKS
・ P. 56 "Ink Pouch Replacement"
292
4. Machine Problems