Correcting Misalignment of the Printing and Cutting Positions
Note: When performing this setting, make sure to set the correction value of [CUTTING MENU CALIBRATION]
to "0.00%. "
P. 124, "Performing Distance Correction During Cutting"
Procedure
Make sure the [AUTO ENV. MATCH] menu item is set to "ENABLE."
P. 128, "Viewing the Automatic Environment Correction Function Settings"
Perform bidirectional adjustment.
P. 111, "Correcting for Misalignment in Bidirectional Printing"
P. 112, "Correcting for Misalignment in Bidirectional Printing More Precisely"
Hold down
CUTTING MENU
PRINT-CUT ADJ.
PRINT-CUT ADJ.
TEST PRINT
To check the test pattern (P&C1)
Check to make sure that the printing position and the cutting position are aligned.
Printing position and Cutting position
are misaligned.
PRINT-CUT ADJ.
TEST PRINT 2
For information on the method of test pattern check, refer to the next page.
and press
.
Press
Press
The test pattern (P&C1) is printed and cut. The test pattern is printed
at three locations on the media: at the two edges and in the center.
When adjustment is needed, go on to the next Procedure.
Cutting position
Printing position
Press
Press
The test pattern (P&C2) is printed and cut.
Fully Utilizing Cutting Function
.
.
Printing position and Cutting posi-
tion are aligned.
to display the left figure.
.
4
125