Roland TrueVIS VG2-640 User Manual page 34

2.
Determine the positions of the media.
Procedure
1.
Determine the left and right positions of the media with the grit patterns used as the reference.
Note the following points when determining the positions.
• Hold the media holders from the outside and move the media.
• Ensure that the left edge of the media is positioned so that it is within the range of the grit pattern of
the left edge.
• Ensure that the right edge of the media is positioned so that it is within the range of one of the grit
patterns.
CAUTION
IMPORTANT
Firmly decide the left and right side positions of the media at this point.
After this procedure is completed, if the left and right side positions do not fit the proper positions when securing the media
with pinch rollers, you will have to go back to this step to redo this procedure. If you just hold the media to readjust its position
forcibly, the media will be skewed during printing, which will have an adverse effect on the printing results.
2.
Secure the media holders by tightening the retaining screws.
Do not hold places other than those instructed. Do not move the media by holding it
directly.
Otherwise the media may fall off the media holder and cause injury.
Setup of Media
33
2. Basic Operations