Step 2: Starting Output - Roland TrueVIS VG2-640 User Manual

Printing and Cutting Output

Step 2: Starting Output

CAUTION
Procedure
1.
In the case of output for the first time on that day, shake the white ink pouch tray.
Remove just the pouch tray for the white ink, shake the pouch tray 50 times (about 20 seconds), and then
reinsert this pouch tray. The precipitation of the ingredients in the ink disables printing in normal color. So
that the ink mixes well, shake the pouch tray horizontally with a stroke length of around 5 cm (2 in.) from
each end of the tray.
IMPORTANT
• The pouch trays for colors other than white do not need to be shaken before every operation, but be sure to shake them
when installing new ones.
• Do not remove the ink pouches. Shake the entire pouch tray. Removing the ink pouches may lead to the ink leaking.
• Before shaking, wipe off any ink from around the mouth of the ink pouch. If you do not wipe off the ink, it may splatter
when you shake the pouch tray.
• When you have finished mixing the ink, reinsert the pouch tray immediately. Taking time to reattach the ink cartridge will
adversely affect the ink path.
• Even if you rarely use white ink, shake the pouch tray for the white ink 50 times (about 20 seconds) once a week.
2.
Close the front cover.
3.
Check that [SETUP] is lit.
If [SETUP] is not lit, the setup is not completed. Lower the loading lever, and then press the [ENTER] key.
4.
Wait until [HEATER] stops flashing and stays lit.
5.
Check that the screen shown below (the top menu) is displayed.
If the top menu is not displayed, press [MENU].
W1100mm
6.
Send the output data from the computer.
For information on how to create the output data, refer to the documentation for the included software RIP.
108
3. Printing and Cutting Method
Never touch the print-head carriage while output is in progress.
The print-head carriage moves at high speed. Coming into contact with the moving carriage may cause
injury.