Step 2: Adjusting Cutting - Roland TrueVIS VG2-640 User Manual

Step 2: Adjusting Cutting

For high-quality cutting, we recommend carrying out a cutting test to check the cutting quality for the media be-
fore you perform actual cutting. Adjust the blade force depending on the cutting quality.
Procedure
1.
Close the front cover.
2.
Press [◀] while the following screen is displayed.
The cutting carriage comes out over the platen.
W1100mm
3.
Press [◀], [▶], [▲], or [▼] to move the cutting carriage to the location where you want to carry out the cutting test.
You can freely set the location for the cutting test.
4.
Press [FUNCTION].
5.
Press [▼] several times to display the screen shown below.
FUNCTION
CUT CONFIG
6.
Press [▶] to display the screen shown below.
CUT CONFIG
TEST CUT
7.
Press [ENTER].
The test pattern is cut.
8.
Press [▼] to display the screen shown below.
CUT CONFIG
FORCE
9.
Press [▶] to display the screen shown below.
FORCE
50gf 50gf
10.
Peel off the cut shapes to verify the cutting quality.
• Two shapes are peeled off separately
You do not need to perform the setting because the blade force is appropriate.
• Two shapes are peeled off together/backing paper is also cut
Proceed to the next step to set the blade force.
11.
Press [▲] or [▼] to select a value.
• Two shapes are peeled off together
Raise the blade force.
• Backing paper is also cut
Preparations before Printing and Cutting Output
3. Printing and Cutting Method
93