Roland TrueVIS VG2-640 User Manual page 126

7.
Correct the misalignment of the printing and cutting positions when using crop
marks.
When you remove the printed media, and then reload it and perform cutting, use the crop marks. For this case,
correction is to be performed because the positioning of printing and cutting may be misaligned even when you
are using crop marks depending on the composition of the media.
Procedure
1.
Press [▶] to select "NEXT".
PRINT-CUT ADJ.
SET [NEXT]
2.
Press [ENTER] to confirm your entry.
3.
Press [◀] or [▶] to select "NEXT" or "SET".
Select "NEXT" when you will not print crop marks. Select "SET" when you will print crop marks.
CROP-CUT ADJ.
[SET] NEXT
4.
Press [ENTER] to confirm your entry.
If you select "SET", the test pattern (C&C1) is printed and cut. Proceed to the next step.
If you select "NEXT", proceed to step 8.
5.
Check the test pattern (C&C1) condition.
Check whether the printing position (shaded part) and the cutting position (outer frame) are aligned. An
example of the printing position and the cutting position being misaligned is shown in the following figure.
"F" indicates the feed direction of the media (the feed direction) and "S" indicates the direction of print
head movement (the scan direction).
6.
Determine whether to correct the misalignment.
• Cutting position and printing position are not aligned
Press [◀] to select "YES".
CONTINUE ADJ.?
[YES] DONE
• Cutting position and printing position are aligned
Press [▶] to select "DONE".
CONTINUE ADJ.?
YES [DONE]
7.
Press [ENTER] to confirm your entry.
• If you select "YES", the test pattern (C&C2) for setting the correction values is printed and cut. Proceed
to the next step.
• If you select "DONE", proceed to step 8.
Cutting with Crop Marks
4. How to Cut with Crop Marks
125