Roland TrueVIS VG2-640 User Manual page 106

8.
Set the drying method and time after printing.
Procedure
1.
Press [◀] or [▶] to select "NEXT".
CROP-CUT ADJ.
SET [NEXT]
2.
Press [ENTER] to confirm your entry.
3.
Press [▲] or [▼] to select [P&C].
Set whether the media should be fed until the trailing edge of the printed area is put on the dryer after the
1st page is printed. To enable this function only for output data designed for printing and cutting, select
"DISABLE". If "DISABLE" is selected, the trailing edge of the printing area is not fed to the dryer unless you
continue with a subsequent printing operation.
FEED FOR DRY
DISABLE P&C
4.
Press [ENTER] to confirm your entry.
5.
Press [▲] or [▼] to set the drying time.
Set the drying time after the 1st page is printed. The next operation is not started until the set time passes.
DRYING TIME
10min 10min
MEMO
This setting is enabled for output data designed only for printing.
This setting is ignored for output data designed for printing and cutting. When the drying time has been set in the software RIP,
priority is given to the software RIP's setting.
Example of setting time (general guide)
The setting time varies according to the settings such as the type of media and the printing quality.
• Condition Non-coated vinyl chloride media
• Setting time: About three minutes
6.
Press [ENTER] to confirm your entry.
7.
Press [▲] or [▼] to set the drying time.
DRY TIME P&C
10min 10min
MEMO
This setting is enabled for output data designed for printing and cutting.
This setting is ignored for output data designed only for printing. This setting is also applied during printing and cutting with
crop marks. Even if the drying time has been set in the included software RIP, priority is given to the setting on this machine.
8.
Press [ENTER] to confirm your entry.
Printing and Cutting Output
3. Printing and Cutting Method
105