Roland TrueVIS VG2-640 User Manual page 86

4.
Save the settings as a preset.
Procedure
1.
Press [▶] to select "NEXT".
PRINT-CUT ADJ.
SET [NEXT]
2.
Press [ENTER] to confirm your entry.
3.
Press [▶] to select "NEXT".
CROP-CUT ADJ.
SET [NEXT]
4.
Press [ENTER] to confirm your entry.
5.
Press [ENTER] when the following screen appears.
These three settings are ignored for output data designed only for cutting. Press [ENTER] and proceed to the
next step.
FEED FOR DRY
DISABLE ENABLE
DRYING TIME
10min 10min
DRY TIME P&C
10min 10min
6.
Press [◀] to select "SAVE".
PRESET
[SAVE] NEXT
7.
Press [ENTER] to confirm your entry.
If you select "NEXT" and press [ENTER], the screen in step 12 is displayed, and the settings you have selected
up to this point are not saved as a preset. However, they will remain as the current setting values for the
machine.
8.
Press [▲] or [▼] to select a destination to save the preset.
You can select a name from NAME1 to NAME8.
SAVE TO
NAME1
9.
Press [ENTER] to confirm your entry.
10.
Set the name.
(1)
Press [▲] or [▼] to select a character.
(2)
Press [▶] to move to the next character.
(3)
Set the following characters in the same way.
You can enter up to15 characters.
SET NAME
11.
Press [ENTER] to confirm your entry.
Cutting Output
85
2. Cutting Method