Roland TrueVIS VG2-640 User Manual page 178

2.
Correct the misalignment of printing and cutting with crop marks at the same
time.
Procedure
1.
Press [MENU].
2.
Press [▲] to display the screen shown below.
MENU
CUTTING MENU
3.
Press [▶], then [▼][▶] to display the screen shown below.
CROP-CUT ADJ.
TEST PRINT
4.
Press [ENTER].
The test pattern (C&C1) is printed and cut. One test pattern is printed on the media.
5.
Check the test pattern (C&C1) condition.
Check whether the printing position (shaded part) and the cutting position (outer frame) are aligned. An
example of the printing position and the cutting position being misaligned is shown in the following figure.
"F" indicates the feed direction of the media (the feed direction) and "S" indicates the direction of print
head movement (the scan direction).
If the printing position and the cutting position are aligned, no corrections are necessary.
If the printing position and the cutting position are not aligned, proceed to the next procedure.
6.
Press [▼] twice to display the screen shown below.
CROP-CUT ADJ.
TEST PRINT 2
7.
Press [ENTER].
The test pattern (C&C2) is printed and cut.
8.
Press [▲] to display the screen shown below.
CROP-CUT ADJ.
SETTING
9.
Check the correction values from the test pattern (C&C2) condition.
The point where the cutting line (
following figure, the correction value is "−0.3."
Check the media feed direction (the feed direction) and the direction of print head movement (the scan
direction).
Accurately Adjusting the Settings for Cutting with Crop Marks
) intersects the correction-value scale ( ) is the correction value. In the
1. Optimizing the Output Quality
177