Using Transparent Media - Roland TrueVIS VG2-640 User Manual

Configuring Settings to Match the Properties of the Media

Using Transparent Media

You can set up transparent media by disabling detection of the leading and trailing edges of the media.
Normally, detecting the leading and trailing edges of the media enables you to verify the presence of the media,
and the media is then ready for setup. However, since transparent media cannot be detected, setup will not be
possible.
Procedure
1.
Press [MENU].
2.
Press [▼] several times to display the screen shown below.
MENU
SUB MENU
3.
Press [▶] to display the screen shown below.
SUB MENU
EDGE DETECTION
4.
Press [▶] to display the screen shown below.
EDGE DETECTION
ENABLE
5.
Press [▲] or [▼] to select "DISABLE".
6.
Press [ENTER] to confirm your entry.
7.
Press [MENU] to go back to the original screen.
MEMO
• Default setting: "ENABLE"
• When set to "DISABLE", printing operation does not stop when the media runs out. If media runs out while printing is in
progress, immediately press [PAUSE] to stop printing. Otherwise, there is a chance that the platen or other parts may be-
come soiled by ink or that ink may get inside and damage the machine.
146
1. Optimizing the Output Quality
ENABLE