Roland TrueVIS VG2-640 User Manual page 50

8.
Set the correction values from "H1" to "H4."
(1)
Press [◀] or [▶] to select a value from H1 to H4.
(2)
Press [▲] or [▼] to select the correction value.
H1 H2
0 0
(3)
When you have finished setting the correction values, press [ENTER].
The screen shown below appears again.
DETAIL SETTING
SETTING NO.1
9.
Press [▼] to display the screen shown below.
DETAIL SETTING
SETTING NO.2
10.
8. Set the correction values from "MEDIA GAP ADJ. NO.2 H1" to "MEDIA GAP ADJ. NO.2 H4" in the same manner as
step.
11.
Press [▼] to display the screen shown below.
MEDIA GAP ADJ.
TEST PRINT
12.
Press [ENTER].
Printing of the test pattern starts.
13.
Check the test pattern to see whether the correction was successful.
For all the correction values, check that the misalignment is minimized for the two vertical lines indicated by
" " (that is, the current correction value). If the misalignment is smaller for another set of vertical lines, set
the correction value again.
14.
When you have successfully performed the correction, press [MENU] to go back to the original screen.
H3 H4
0 0
What to Do First after Installation
2. Basic Operations
49