3.
Perform a cutting test (separate test for printing/cutting with crop marks).
Procedure
1.
Set up the media for which operations before cutting output, such as lamination, is complete.
2.
Press [◀] while the following screen is displayed.
The cutting carriage comes out over the platen.
W1100mm
3.
Press [◀], [▶], [▲] or [▼] to move the center of the blade over the crop marks.
4.
Once the position has been decided, press [FUNCTION] to display the screen shown below.
FUNCTION
BASE POINT
5.
Press [ENTER] to confirm your entry.
When the screen displays the character "B" together with the printable width at the location (as shown in
the following figure), setting is completed.
W1100mm
B
6.
Press [MENU].
7.
Press [▲] to display the screen shown below.
MENU
CUTTING MENU
8.
Press [▶], then [▼] to display the screen shown below.
CUTTING MENU
CROP-CUT ADJ.
9.
Press [▶] twice, and then press [▼] once to display the screen shown below.
TEST PRINT
CUT ONLY
10.
Press [ENTER].
The cutting test starts.
Accurately Adjusting the Settings for Cutting with Crop Marks
1. Optimizing the Output Quality
181