Switching Off The Print Heater And Dryer Together - Roland TrueVIS VG2-640 User Manual

Adjusting the Ink-drying Method

Switching Off the Print Heater and Dryer Together

This setting is useful when you want to switch off the media heating system collectively, such as when performing
only cutting. Setting the heater settings "POWER" to "OFF" will cause temperature settings of the print heater and
dryer to become impossible.
Procedure
1.
Press [FUNCTION].
2.
Press [▼] several times to display the screen shown below.
FUNCTION
HEATER CONFIG
3.
Press [▶] to display the screen shown below.
HEATER CONFIG
POWER
4.
Press [▶].
5.
Press [▲] or [▼] to select "OFF."
HEATER CONFIG
ON
6.
Press [ENTER] to confirm your entry.
The settings for the print heater and dryer are turned off.
7.
Press [FUNCTION] to go back to the original screen.
MEMO
• Default setting: "ON"
IMPORTANT
When this is set to "OFF", the heater will not turn on even if the heater temperature is set in the included software RIP.
160
1. Optimizing the Output Quality
ON
OFF