Roland TrueVIS VG2-640 User Manual page 95

Preparations before Printing and Cutting Output
Reduce the blade force.
12.
Press [ENTER] to confirm your entry.
13.
Press [▲] to display the screen shown below.
CUT CONFIG
TEST CUT
14.
Press [ENTER].
The test pattern is cut.
15.
Check whether the correction was successful.
At the [CUT CONFIG] menu, you can also make settings for other cutting conditions in addition to the blade force.
Refer to the following page.
RELATED LINKS
・ P. 163 "Fine-tuning the Cutting Conditions"
94
3. Printing and Cutting Method