Preventing Soiling Of The Media And Dot Drop-Out - Roland VersaArt RE-640 User Manual

Accommodating to the Types and Condition of Media
Description
This makes the setting for distance from the left or right media clamp to the corresponding left or right edge
of the printing area. You can select either "5 mm", "10 mm," or "25 mm." Setting this to "5 mm" lets you expand
the printing area.
 P. 130, "Maximum Area and Margins"
Note, however, that when you're using transparent media, setting this to "5 mm" may result in printing on
top of the media clamps.
Default Setting
[SIDE MARGIN]: 10 mm

Preventing Soiling of the Media and Dot Drop-out

Procedure

Press

MENU
SUB MENU
4

SUB MENU
PERIODIC CL.

PERIODIC CL .
NONE
Current
setting

W1200mm
SETUP SHEET
Description
In the following cases, Ink tends to collect on the surface of the heads. Under some conditions, this ink may
be transferred to the media or cause dot drop-out. Use this feature at such times.
 When you use media prone to buildup of static charge.
 When the ambient temperature is low.
 When the head height is set to "HIGH. "
Selecting "PAGE" or a value from "10 min" to "990 min," the ink buildup is removed before or during printing
while printing is performed. Note, however, that using "PAGE" or a value from "10 min" to "990 min," results
in longer printing times.
Default Setting
[PERIODIC CL.]: NONE
100
.
Press
Press
Press
Press
Press
10 min
PAGE
Automatic cleaning is performed every time before printing starts.
Setting after
10 to 990 min
change
Automatic cleaning is performed when the cumulative printing time
reaches the value you set here.
NONE
Automatic cleaning is not performed.
Press
Press
several times to display the left figure.
.
several times to display the left figure.
.
to select an item.
to enable the setting.
to go back to the original screen.