Avaya Definity SI Maintenance Manual page 40

Maintenance Architecture
7. Find the DID-TRK MO in the Maintenance Object chapter of the
appropriate maintenance book.
8. In the first table look up the initial command to run in the MAJOR row of the
table (Step 4 indicated that a DID trunk in slot 10, carrier C has a MAJOR
alarm).
MO Name (in
Alarm Log) Alarm Level
DID-TRK MAJOR
DID-TRK MINOR
DID-TRK WARNING
1. UU is the universal cabinet number (1 for PPN, 2 - 44 for EPNs), C is the carrier designation (A, B,
C, D, or E), SS is the number of the slot in which the circuit pack resides (01 to 21), and pp is the
two digit port number (01, 02,...).
2. A MAJOR alarm on a trunk indicates that alarms on these trunks are downgraded by the set options
command and that at least 75% of the trunks in this trunk group are alarmed.
9. Type test port 01C1008 long and press
"01C1008" is the address of the alarmed port
Screen 1-3 on page
10. While the port test is running, look up the Error Type (1537 from
1-3) in the DID Trunk Error Log Entries table (example below).
Table 1-2. DID Trunk Error Log entries
Error Aux
Type Data Associated Test
1537 Port Diagnostic (#35)
3840(k) 40965 None
11. Since the Test to Clear Value (
initial test you ran in Step 11, wait for the results of the port test.
12. When the port test finishes, the following screen appears
Port Maintenance Name
01C1008 DID-TRK
Screen 1-4. Test Results screen
13. Find the Port Diagnostic Test (#35 from Test No.) in the DID-TRK section
of the Maintenance book. Note the Error Code (61472).
1-4 Issue 4 May 2002
Initial Command to Run
2
test port UUCSSpp long
test port UUCSSpp long
test port UUCSSpp
1-3)
Alarm Level
MAJ/MIN/WRN
test port 01C1008 sh r 1) is very similar to the
TEST RESULTS
Alt. Name Test No.
35
1
Full Name of MO
DID Trunk
DID Trunk
DID Trunk
.
Enter
(Screen 1-2 on page 1-3
On/Off
Board Test to Clear Value
OFF test port UUCSSpp sh r 1
Result Error Code
FAIL 61472
and
Screen
(Screen 1-4):
555-233-123