Safety Information - Alcatel-Lucent 7302 Information Manual

NTP 112 — Install a G-010V-P ONT

Safety information

Read the following safety information before installing the unit.
Procedure
Use this procedure to install a G-010V-P ONT.
1 Prepare the cables at the site where the ONT will be installed (DLP 100).
2 Are any of the cables missing?
a
b
3 Locate each missing cable and route them to the ONT as per local practices.
4 Place the ONT on the flat surface vertically or horizontally as needed.
5 Review the connection locations shown in Figure
NTP 112-2 November 2013
Danger 1 — Contact the local utility company before you connect the
enclosure to the utilities.
Danger 2 — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning — This equipment is ESD sensitive. Proper ESD protections
should be used when removing the fiber access cover of the ONT.
Caution — Keep indoor ONTs out of direct sunlight. Prolonged
exposure to direct sunlight can damage the unit.
Note — Observe the following:
The ONT should be installed in accordance with the applicable
•
requirements of the NEC or CEC. Local authorities and practices take
precedent when there is conflict between the local standard and the
NEC or CEC.
The ONT must be installed by qualified service personnel.
•
Indoor ONTs must be installed with cables that are suitably rated
•
and listed for indoor use.
See G-010V-P detailed specifications
•
for the temperature ranges for ONTs.
If yes, go to step 3.
If no, go to step 4.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
in the G-010V-P unit data sheet
NTP 112-1 for G-010V-P ONTs.
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide