Safety Information - Alcatel-Lucent 7302 Information Manual

NTP 142 — Install an I-020E-B, I-020E-H, or I-020G-F indoor ONT

Safety information

Read the following safety information before installing the unit.
Procedure
Use this procedure to install an I-020E-B, I-020E-H, or I-020G-F indoor ONT.
1 Prepare the cables at the site where the ONT will be installed (DLP 100).
2 Will the ONT sit on a flat surface, or be mounted to a wall?
a
b
3 Slip the wall mount bracket over the ONT.
i
ii
iii
NTP 142-2 November 2013
Danger 1 — Contact the local utility company before you connect the
enclosure to the utilities.
Danger 2 — Observe the local and national laws and regulations that
may be applicable to this installation.
Warning — This equipment is ESD sensitive. Proper ESD protections
should be used when handling the indoor ONT.
Caution — Keep indoor ONTs out of direct sunlight. Prolonged
exposure to direct sunlight can damage the unit.
Note — Observe the following:
The indoor ONT should be installed in accordance with the
•
applicable requirements of the NEC or CEC. Local authorities and
practices take precedence when there is conflict between the local
standard and the NEC or CEC.
The indoor ONT must be installed by qualified service personnel.
•
Indoor ONTs must be installed with cables that are suitably rated
•
and listed for indoor use.
See "I-020E-B, I-020E-H, and I-020G-F detailed specifications"
•
unit data sheet for the temperature ranges for these ONTs.
For ONTs that will be wall mounted, go to step
For ONTs that will sit on a flat surface, go to step 5.
Measure and drill two holes in the wall where the ONT will be mounted. The
holes should be the same distance apart as the holes on the wall mounting
bracket (83.3 mm apart, or 3.28 in).
Place mounting screws or bolts in the wall.
Lay the ONT flat on a table.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide
in the