Service Data Set; Service Data Provisioning Parameters Per Port - Alcatel-Lucent 7302 Information Manual

Parameter Description
dtmf_volume_le Specifies the volume field sent in the
vel RFC 2833 packets that encode DTMF
from the attached phone. When the
parameter is set to measured, then
the volume of the tone received in
dBm0 from the attached phone will
be reported in the RFC 2833 packets.
When the parameter is set to an
integer between 0 and 55, then that
value will be used in the volume field
of any transmitted RTC 2833 packets
signaling DTMF. The default is
measured.
(5 of 5)

Service data set

Table
TL1 can be used to configure equivalent parameters on systems supporting OMCIv2.
Table 5-14 Service data provisioning parameters per port
Parameter Description
digit_map A mandatory pattern that guides
digit collection and allows the
DigitMap
user agent to determine when
dialing is complete. One
digit_map setting is supported
for each POTS port. See Table
5-15
map contents. This is a string of
up to 1093 characters and is a
required parameter with no
default value. A digit map must
be customized for each SIP
implementation based on the
features of the SIP server in the
network.
White space in the digit map
string is not significant.
Characters are case insensitive.
Some devices use MGCP formats.
Contact your support
representative for more
information.
For I-240W-S ONTs, all lines
should be configured to use the
same digitmap.
(1 of 30)
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
5-14 lists the service parameters per port. When OMCIv2 support is yes, then
for a description of the digit
Mode Mode Device
1 2
N Y All
except
package
C, D,
and E
Mode Mode Device
1 2
Y Y All
November 2013
5 — VoIP overview
OMCIv2 TL1 or CLI
support? parameter
No, value N/A
is derived
from
FTP/defau
lt line
profile.
OMCIv2 TL1 or CLI
support? parameters
Yes N/A
5-43