Ntp 119 — Replace An I-010G-A Indoor Ont; Required Tools - Alcatel-Lucent 7302 Information Manual

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

NTP 119 — Replace an I-010G-A indoor

This DLP provides the steps to replace an I-010G-A indoor ONT.

You must issue TL1 commands at the P-OLT before you replace an I-010G-A indoor ONT

at the subscriber site, and again before you can verify the subscriber services.

Prerequisites

The prerequisites are:

network management access or craft port access to the P-OLT that supports the

I-010G-A indoor ONT to be replaced.

serial number of the replacement I-010G-A indoor ONT.

Ensure that any debugging sessions are disabled. You can re-enable debugging after

the procedure is complete.

For information about TL1 command syntax, see the operations and maintenance

documentation for the OLT.

The required tools are:

wire strippers

#2 Phillips screwdriver

fiber optic splicing tools

RJ-45 cable plug crimp tool

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

3FE 55873 AAAA TCZZA

ONT Product Information Guide

November 2013