I-241G-Q Indoor Ont Physical Connections; I-021G-P And I-241G-Q Indoor Ont Physical Connections; I-021G-P And I-241G-Q Leds - Alcatel-Lucent 7302 Information Manual

Table
ONTs.
Connection
Ethernet ports
RF video coaxial
POTS connections
(I-241G-Q ONT only)
Power
Fiber optic
Note
(1) The primary path for the earth ground for these ONTs is provided by the 12V Return signal in the
power connector.
23.5

I-021G-P and I-241G-Q LEDs

Figure
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Figure 23-2 I-241G-Q indoor ONT physical connections
G E 1
23-4 describes the physical connections on I-021G-P and I-241G-Q indoor
Table 23-4 I-021G-P and I-241G-Q indoor ONT physical connections
(1)
Description
This connection is provided through Ethernet RJ-45 cables. For the
I-021G-P ONT, up to two 10/100/1000 Base-T Ethernet interfaces are
supported. For the I-241G-Q ONT, up to four 10/100/1000 Base-T
Ethernet interfaces are supported.
The Ethernet ports can support both data and in-band video services on
both interfaces.
This connection is provided through an F-Type coaxial connector.
This connection is provided through an RJ-11 phone connector. Up to
two POTS interfaces are supported.
This connection is provided through the power connector. A power
cable fitted with a barrel connector is used to make the connection.
This connection is provided through a SC/APC fiber optic connector.
The fiber optic connector is located behind a fiber optic port cover on
these ONTs.
23-3 shows the I-021G-P indoor ONT LEDs.
23 — I-021G-P and I-241G-Q unit data sheet
P O T S 2
P O T S 1
R F
G E 2
G E 1
G E 2
F-Type
coaxial
Ethernet
ports
November 2013
Fiber optic
connector
Power
P W R
R E S E T
connector
Reset
button
POTS
ports
22657
23-5