Procedure 6-42 To Clear The Slid; Procedure 6-43 To Enter The Slid - Alcatel-Lucent 7302 Information Manual

Procedure 6-42 To clear the SLID

1 Perform one of the following:
a
b
2 Choose option 5, Clear SLID, from the
The ONT sets the SLID to the default value, and the following message appears:
SLID cleared successfully!
3 Choose option 4, Retrieve SLID from the main menu to verify that the SLID is reset
to its default value.
4 STOP. This procedure is complete.

Procedure 6-43 To enter the SLID

1 Perform one of the following:
a
b
2 Choose option 4, Retrieve SLID, from the
to DEFAULT or null.
3 Perform one of the following from the main menu
a
b
c
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
If you are using an Ethernet port, ensure that the ONT is disconnected from
the PON optical cable.
If you are using a craft port, you can clear the SLID with the ONT connected
to or disconnected from the PON optical cable.
If you are using an Ethernet port, ensure that the ONT is disconnected from
the PON optical cable.
If you are using a craft port, you can enter the SLID with the ONT connected
or disconnected from the PON optical cable.
Choose option 1, Enter SLID in volatile mode, to enter a volatile SLID.
Choose option 2, Enter SLID in permanent mode, to enter a non-volatile
SLID delivered in proprietary mode.
Choose option 3, Enter SLID in registration mode, to enter a non-volatile
SLID delivered in registration ID mode.
The following appears:
Enter Subscriber Location Id
> ALPHANUMERIC MODE (Length(1..10)):
> HEX MODE (Length(1..20))
> Note: FOR HEX MODE -- APPEND THE VALUE WITH 0x
6 — ONT management using an ONT interface
Main menu to clear the SLID.
Main menu to ensure that the SLID is set
November 2013 6-61