3
Press Enter.
4
If necessary, reboot the ONT (Procedure 6-28) in order for the new SLID to take
effect immediately.
5
STOP. This procedure is complete.
Procedures using butt set
The following procedures provide the steps to clear the SLID and to enter a SLID at
the ONT using a butt set.
Procedure 6-48 To clear the SLID using a butt set
1
Ensure that the ONT is disconnected from the PON optical cable.
2
Reboot the ONT.
3
Connect the butt set to the first POTS port on the ONT.
4
Wait for the green POTS LED on the ONT to start flashing (one second on, and two
seconds off).
5
Take the butt set off-hook.
6
Dial "*1#" to convert the permanent SLID to a volatile SLID.
When the ONT is powered off and on, the SLID is reset to its default value.
7
Power the ONT off and on to reset SLID to its default value.
8
Take the butt set on-hook to exit.
9
STOP. This procedure is complete.
Procedure 6-49 To enter the SLID using a butt set
1
Ensure that the ONT is disconnected from the PON optical cable.
2
Connect the butt set to the first POTS port on the ONT.
3
Wait for the green POTS LED on the ONT to start flashing (one second on, and two
seconds off).
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA
Edition 01
ONT Product Information Guide
Note —
To use a butt set:
•
The ONT must be disconnected from the PON optical cable.
•
The butt set must be connected to the first POTS port on the ONT.
•
The SLID must be in decimal or hexadecimal format.
6 — ONT management using an ONT interface
November 2013
6-65