NTP 160 — Install an I-211M-K or I-211M-L indoor ONT
Grommet
Buried cable
entry point
Cable feeds to ONT
(actual length varies, but a minimum of approximately 18 in.)
NTP 160-8
November 2013
Figure NTP 160-5: Coiled cable routing (open view)
iii
Cut the width of the cable off of the end of the grommet.
iv
Reinstall the grommet into the slot over the cable.
v
Coil the excess cable in a clockwise direction, allowing enough cable to
exit the lower right cable exit port; see Figure
Note — Observe the following:
There must be adequate length for the fiber optic cable to curve
•
around and maintain minimum bend radius, enter into the ONT
enclosure and make the optical connection.
There must be approximately 20 in. (50 cm) of cable exiting the FSST
•
at the right cable exit point.
The FSST stores a maximum of 75 ft (22.86 m) of cable.
•
vi
Secure the fiber optic cable with the coil retention clamp; see
Figure
NTP
160-5.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Grommet
Coil retention clip
NTP
Edition 01
3FE 55873 AAAA TCZZA
ONT Product Information Guide
Aerial cable
entry point
(optional)
18812
160-5.