Ntp 103-3: B-0404G-B Business Ont Connections - Alcatel-Lucent 7302 Information Manual

NTP 103 — Install a B-0404G-B business ONT
10 Connect the ground wire (DLP 147). Optional, as required.
The ground is a range of 1/2 to 5/8 inch strip length with outer jacket aligned with
the outer surface of the enclosure.
11 Connect up to four Ethernet cables to the RJ-45 ports (DLP 101).
12 Connect up to four DS1 cables to the RJ-48C ports (DLP 104).
13 If used, configure the SLID (DLP 129).
14 Connect the fiber optic cable to the B-0404G-B business ONT.
i
ii
15 Connect the B-0404G-B business ONT to a UPS.
i
ii
16 Verify the ONT LEDs, voltage status, and optical signal levels (DLP 127).
17 Activate and test the services (DLP 128).
18 STOP. This procedure is complete.
NTP 103-6 November 2013
Figure NTP 103-3: B-0404G-B business ONT connections
2
E T H
1
E T H
Ethernet
(RJ45) ports
Route the fiber optic cable to the ONT.
Plug the SC/APC adaptor into the fiber optic port located on the back of the
ONT unit (DLP 125).
Install the UPS (DLP 110).
Plug the optional 8-pin Molex output power cord in to the ONT power
connector (DLP 115).
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
D S 1 4
3
D S 1
2
D S 1
1
D S 1
4
E T H
3
E T H
Ground
DS1 ports
(RJ-48C)
Edition 01
ONT Product Information Guide
Fiber optic
connector
Power
connector
23281
3FE 55873 AAAA TCZZA