Ntp 115-1: G-241W-P And I-241W-T Indoor Ont Connections - Alcatel-Lucent 7302 Information Manual

4 Place the indoor ONT unit:
a
b
5 Review the connection locations as shown in Figure
I-241W-T indoor ONTs.
6 Connect the Ethernet cables to the RJ-45 ports (DLP 101).
7 Connect the POTS cables to the RJ-11 ports (DLP 123).
8 Connect the coaxial cable to the F-Type connector (DLP 116).
9 Connect the SC/APC fiber optic cable (DLP 125).
10 Connect the power cable to the power connector.
11 Power up the ONT unit by using the ON/OFF power switch.
12 If used, enable the Wi-Fi service using the Web GUI.
13 Verify the ONT LEDs, voltage status, and optical signal levels (DLP 127).
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
On the flat surface, such as a desk.
i Wrap the excess optic cable inside the fiber storage tray.
ii Attach the fiber storage tray to the ONT.
iii Place the ONT on the flat surface, horizontally resting on its four feet
as shown in Figure
iv Go to step 5.
On a wall (DLP 122).
Figure NTP 115-1: G-241W-P and I-241W-T indoor ONT connections
F-Type
coaxial
connector
R F
Po w
er
O N /O
FF
Power
P O TS
connector
Power POTS
on/off ports
switch (RJ-11) Ethernet
(RJ-45)
Warning — Be careful to maintain a bend radius of no less than 1.5
inches (3.8 cm) when connecting the fiber optic cable. Too small of a
bend radius in the cable can result in damage to the optic fiber.
NTP 115 — Install a G-241W-P or I-241W-T indoor ONT
NTP 115-1.
1
P O TS
2
LA N
1
LA N
2
LA N
3
LA N
4
U S B
1
U S B
2
ports
USB
ports
November 2013
NTP 115-1 for G-241W-P and
23554
NTP 115-3