Sfu Cabling With And Without Moca; Planning Maintenance; Monitoring - Alcatel-Lucent 7302 Information Manual

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

SFU customer premise

Switching existing services from a service provider can be a challenge. For example,

an existing copper network interface device may be many feet away from the ONT,

while the coaxial splitter may be at the opposite end of the premises. In this case,

some of the options are:

Install the ONT on top of the existing network interface device and use the ONT

as the new network interface device.

Run copper and coaxial jumpers from the ONT to the network interface device

and the RF splitter.

New housing and MDU developments provide an opportunity to optimize the wiring

design to support the offered services. The options include:

specifying a central wiring and cabling closet or box

installing the ONT indoors and running fiber directly to the ONT from the outside

This section provides information about planning ONT maintenance.

The system provides maintenance tools. The 5520 AMS can be used to monitor

alarms and performance. In addition, TL1 and CLI commands can be used at the craft

terminal at the OLT or the ONT/MDU (if supported) to perform monitoring tasks.

Monitoring alarms and performance provide some troubleshooting, but do not

provide the granularity needed for fault isolation.

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

3FE 55873 AAAA TCZZA

ONT Product Information Guide

2 — Part numbers, ordering, and deployment configuration overview

Figure 2-5 SFU cabling with and without MoCA

SFU customer premise w/MOCA

November 2013