Procedure 6-9 To Disconnect From The Cli Interface; Procedure 6-10 To Retrieve Product Information For An Ont - Alcatel-Lucent 7302 Information Manual

6 — ONT management using an ONT interface

Procedure 6-9 To disconnect from the CLI interface

1 Type X or x for Exit from the
2 Perform one of the following:
a
b
3 STOP. This procedure is complete.
6.5 Retrieving product information for an ONT
Product information about an ONT includes the vendor name, firmware, type of
ONT (mnemonic only), and serial number.
This section shows you how to retrieve product information for an ONT.
Prerequisites
The prerequisites are:
•
The user access level of the ONT is read-write.
•
The steps to access the interface are completed.
•
•
•
Procedures using HTTP interface
The following procedure provides the steps to retrieve product information using the
HTTP interface.

Procedure 6-10 To retrieve product information for an ONT

1 From the Web-Management System window, click on the Product Information
tab, as shown in Figure 6-6.
The Product Information window opens with the product information for the
ONT, as shown in Figure 6-7.
6-18 November 2013
If you are connected to the CLI interface through a craft port, disconnect the
serial cable from the RS-232 connector.
If you are connected to the CLI interface through an Ethernet port,
disconnect the Ethernet cable from the Ethernet port.
See Procedure 6-1 for HTTP interface using the first Ethernet port.
See Procedure 6-4 for CLI interface using the first Ethernet port.
See Procedure 6-6 for HTTP interface for Package C ONTs
Figure 6-6 Main options in the Web-Management System window
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
SLID menu at any time during the session.
Edition 01
ONT Product Information Guide
3FE 55873 AAAA TCZZA