Ntp 122-3: Molex 8-Pin Connector - Alcatel-Lucent 7302 Information Manual

Intelligent services access manager

Hide thumbs Also See for 7302:

Table of Contents

Figure NTP 122-2: Power connector pin configuration for I-010G-B, I-020G-M, and

power connector is exactly the same and in the same location on the I-010G-B

Power up the ONT unit by using the ON/OFF power switch.

If necessary, reset the ONT (DLP 126).

If used, configure the SLID (DLP 129).

Verify the ONT LEDs and voltage status (DLP 127).

Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02

3FE 55873 AAAA TCZZA

ONT Product Information Guide

NTP 122 — Replace an I-010G-B, I-020G-M, or I-040G-B indoor ONT

I-040G-B indoor ONTs

shows the power connector on an I-040G-B indoor ONT. The

Figure NTP 122-3: Molex 8-pin connector

Note — A new SLID or the old SLID may be used with the replacement

ONT. If a new SLID is used, the new SLID must also be programmed at

the P-OLT using TL1 or a network manager. If the old SLID is used, no

changes need to be made at the P-OLT; see the appropriate P-OLT

Operations and Maintenance Procedures Guide for more details.

November 2013