Pots Voice Support For Sip; Vdsl2 Interface Specifications - Alcatel-Lucent 7302 Information Manual

3 — ONT and MDU general and interface technical specifications
•
The ONT has one MAC address associated the VoIP client.
•
The ONT supports a configurable IP address for the VoIP client.

POTS voice support for SIP

To ensure high quality delivery of SIP-based VoIP services in SIP Mode 1 (thin
client), Alcatel-Lucent recommends the following values for the bandwidth profile
for each POTS line:
•
Committed Information Rate (CIR) of 150 Kb/s
•
Excess Information Rate (EIR) of 150 Kb/s
•
Delay Tolerance (DT) of 8
For multiple POTS lines providing SIP-based VoIP service in SIP Mode 1, use a
multiple of the recommended per-line EIR and CIR values. For example, with 4
POTS lines, use CIR of 600 Kb/s, EIR of 600 Kb/s, and DT of 8.
To ensure high quality delivery of SIP-based VoIP services in SIP Mode 2 (thick
client), Alcatel-Lucent recommends the following values for the bandwidth profile
for each POTS line:
•
CIR of 250 Kb/s
•
EIR of 250 Kb/s
•
DT of 8
For multiple POTS lines providing SIP-based VoIP service in SIP Mode 2, use a
multiple of the recommended per-line EIR and CIR values. For example, with 4
POTS lines, use CIR of 1000 Kb/s, EIR of 1000 Kb/s, and DT of 8.
3.5

VDSL2 interface specifications

Similar to ADSL, VDSL2 operates over the copper wires in a telephone line to
provide both high-bandwidth service and POTS, and is asymmetric in its
downstream and upstream speeds. However, VDSL2 provides subscribers with a
higher bit rate than multi-ADSL and can achieve speeds over 57 Mb/s downstream
and 25 Mb/s upstream, compared with 24 Mb/s downstream and 1.3 Mb/s upstream
with multi-ADSL. The maximum bit rates supported depend on deployment, noise
environment, and Ethernet system restrictions. The high bit rate asymmetrical mode
can be used for high-bandwidth video service, while the symmetrical bit rate mode
can be used for business users or residential users who need symmetrical bit rate
access. The VDSL2 ports support loop lengths of 300 meters nominal.
VDSL allows very high speed data transmission on a metallic twisted pair between
the operator network and the customer premise. This service is provisioned by using
the existing unshielded copper twisted pairs, without requiring repeaters. By using a
Frequency Division Multiplexing technique, the existing POTS or BR ISDN services
can still be provided on the same wires. VDSL transceivers use Frequency Division
Duplexing (FDD) to separate upstream and downstream transmission.
Each end of the VDSL line is terminated by a VDSL Termination Unit (VTU), as
shown in Figure 3-1. The unit at the (optical) network side is the VTU-O (MDU) and
the Remote or Customer Premises (CP) unit is the VTU-R.
3-10 November 2013 Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
Edition 01 3FE 55873 AAAA TCZZA
ONT Product Information Guide