Ntp 137-1: I-111G-A Indoor Ont Connections - Alcatel-Lucent 7302 Information Manual

Type F coaxial
connector
Figure
I-011G-A, I-011G-B, and I-110G-A ONTs are identical to the I-111G-A ONT except
the I-011G-A and I-011G-B ONTs do not have a POTS port and the I-110G-A ONT
does not have a Type F coaxial connector.
4 Disconnect the SC/APC adaptor from the fiber optic connector on the ONT
(DLP 133); see Figure
5 Replace the ONT with a new unit:
a
b
c
6 Connect the Ethernet cable to the RJ-45 ports (DLP 101).
7 Connect POTS and coaxial cables as required:
a
b
c
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
NTP 137 — Replace an I-011G-A, I-011G-B, I-110G-A, or I-111G-A indoor ONT
Figure NTP 137-1: I-111G-A indoor ONT connections
POTS POTS2 LAN
1
U
S
B
2
TV
POTS port Ethernet port
(RJ-11) (RJ-45)
NTP 137-1 shows the connections for an I-111G-A indoor ONT. The
NTP 137-1.
On a flat surface, such as a desk, substitute the replacement ONT for the old
ONT that is resting horizontally; go to step 6.
In a stand.
i Unsnap the old ONT from the channels built into the stand. Snap the
new ONT into channels built into the stand, ensuring it is securely held.
ii Place the new ONT with stand vertically on a flat surface; go to step 6.
On a wall.
i Slide the old ONT upward and then away from the two mounting screws
until the ONT is free of the wall.
ii Slide the wall mount keyholes on the ONT enclosure or fiber storage tray
of the replacement ONT down over the mounting screws until it is
securely seated.
For the I-111G-A indoor ONT, connect the POTS cable to the RJ-11 port
(DLP 123) and the coaxial cable to the Type F connector (DLP 116).
For the I-110G-A indoor ONT, connect the POTS cable to the RJ-11 port
(DLP 123).
For the I-011G-A and I-011G-B indoor ONT, connect the coaxial cable to the
Type F connector (DLP 116).
Power connector
LAN2 LAN3 LAN4
POWER
Power
switch
November 2013
Fiber
optic
connector
20481
NTP 137-3