Http Interface - Alcatel-Lucent 7302 Information Manual

Security
The HTTP and CLI interfaces are password-protected to prevent unauthorized access
to utilities. In addition, each ONT has a security setting that specifies the access level
of a user to the HTTP and CLI interface utilities, after the ONT is ranged. User access
levels are as follows:
•
read-write access, which grants a user read and write access to all utilities
•
read-only access, which grants a user read-only access to the SLID, ranging state,
and RSSI of the ONT
•
no access, which denies a user access to all utilities

HTTP interface

The HTTP interface is GUI-based. Figure
the main parts of the interface labeled. The following sections describe these parts.
Alcatel-Lucent 7302 ISAM | 7330 ISAM FTTN | 7360 ISAM FX ONT R04.06.02
3FE 55873 AAAA TCZZA Edition 01
ONT Product Information Guide
Note 1 —
Contact the CO for the level of access that has been set for
a specific ONT.
Note 2 —
The HTTP and CLI interfaces require a specific username
and password. Contact your Alcatel-Lucent technical support
representative for username and password information.
Note 3 —
The following exceptions apply to security.
•
If the PON is out of service, you have read-only access to the
SLID, ranging state, and RSSI of the ONT, regardless of the access
level of the ONT.
•
If the ONT or the Ethernet port on the ONT is out of service, you
cannot log in to the ONT using the HTTP or CLI interface.
6 — ONT management using an ONT interface
6-1 shows a sample HTTP interface, with
November 2013 6-5